Emulsified oil manufacturers will talk about the combustion process of emulsified oil

Emulsified oil manufacturers will talk about the combustion process of emulsified oil

Emulsified oil manufacturer: Emulsified oil combustion process

The physical effect of the combustion process of emulsified oil is the so-called "micro-explosion" theory. The water-in-oil molecular group, oil is a continuous phase, and water is a dispersed phase. Because the boiling point of oil is higher than that of water, water always reaches the boiling point first, and evaporates or boils after heating. When the pressure in the oil droplets exceeds the sum of the surface tension of the oil and the ambient pressure, the water vapor will break through the resistance of the oil film, causing the oil droplets to explode and form finer oil droplets. This is the so-called micro-explosion or secondary atomization. The tiny oil droplets after the explosion are easier to burn. Therefore, the oil burns more completely, so that the internal combustion engine or oil furnace can achieve the effect of energy saving. Chemistry is the reaction of water vapor. Under the condition of anoxia, the carbon particles produced by pyrolysis in the fuel can react with water vapor to generate CO2 and H2. The carbon particles are fully burned, the combustion rate is increased, and the soot content in the exhaust gas is reduced.

Emulsified oil manufacturers: production process of emulsified oil

It is difficult to make water-in-oil particles mixed with oil, water and additives, with a diameter of microns and a stability period of 3 months or even half a year.

The choice of additives is related to factors such as the calorific value, flash point, and stability period of the additive fuel. In addition, fuel economy and good additive performance should also be considered. However, if it is not economical, emulsified oil is more expensive than diesel or gasoline, and there is obviously no market. Therefore, there is no way out. I am afraid it is an important reason why many of our studies cannot go to the market. Therefore, the selection of additives requires a lot of experiments to optimize the ideal additive formula, which varies depending on the application object.

Emulsified oil can mechanically stir, cut, mix and atomize oil, water and additives in proportion to make the particle size meet the requirements.

Emulsified oil manufacturers: technical difficulties of emulsified oil compounds

It is understood that the production of emulsified oil complexes is to mix oil, water and additives together to form water-in-oil particles with a diameter of microns and a stabilization period of 3 months or even half a year, which is difficult to manufacture.

It should be known that emulsified oil compounding is the choice of additives, which is related to factors such as calorific value, flash point, and stabilization period of additive fuels.

In addition, fuel economy should also be considered. The performance of emulsified oil compound additives is good, but if it is not economical, the emulsified oil made is more expensive than diesel or gasoline. Obviously, there is no market, so there is no future. I am afraid that many of our studies cannot go to the market. an important reason.

Therefore, the selection of emulsified oil compound additives requires a lot of experiments to optimize the ideal additive formula, which varies depending on the application object.

The above is the "burning process of emulsified oil" explained by the editor of the emulsified oil manufacturer. I hope the content is helpful to everyone. Thank you for watching. See you next time.